Controller pin 6 is not wired.
Generally not, if the controller needs to output a signal to start the generator, it needs to be connected to a DC power supply.
The external power supply is abnormal.
If the circuit breaker trips due to overload or short circuit, the alarm should be released by pressing the up and down arrows at the same time.
First check if the insurance is functioning properly, and then check if the terminals are loose.
Select "Function Settings" in the "Parameter Settings" section of the controller, and then select "Non self resetting" in the bus reset mode.
Press and hold the "OK" button for 3 seconds to clear the alarm.
The factory default closing and opening delay time of the controller is 10 seconds. The customer can adjust the integrated opening delay time in the "parameter setting" of the controller according to the site needs.
Both with and without undervoltage release are acceptable, but there is a slight difference in the wiring diagram. We usually recommend using an undervoltage release device.
- 地址：Building C2-1, 3F, No. 2999 Nanyang Avenue, Yaoxi Street, Longwan District, Wenzhou City, Zhejiang Province
- 电话：0577-86581300 0577-86581918
- 传真：0577-86581301
- 手机：13868309943 13857725758
- 邮箱：wv@chinawangwei.com
- 网址：www.chinawangwei.com
- 4006-988-180
- 1987266146
